Size:Small (Fits with our Daibo Flannel Dripper)
Material: Cotton

Made in Japan

This product uses natural wood. Do not leave it wet or put next to heat in order to avoid cracks and molds.

Before usage:
Remove wooden holder. Wash with hot water and remove moisture by squeezing tightly and using clean towel.

After usage:
Remove wooden holder. Dispose coffee grounds and wash filter with hot water. Do not use detergent.

Storage:
- After following "before usage," leave it to dry.
- For short storage, set the nel filter inside a container filled with water and keep it cool inside refrigerator. Change water 1-2 times a day. Make sure to remove wooden holder and keep it stored separately.
- Store in the freezer if you do not plan to use it for a long time. Make sure to remove wooden holder and keep it stored separately.

*Change nel filter itself when you start to notice slow flow rate and distinct stains. 

Please also check out our recipe!

What you'll need:

- a short sewing needle

- a thread (Polyester cotton, 40 weight), about 100cm, use as a double thread

- a pair of scissors and a thimble (if needed)

***

1. Spread open the top of the double-side ear (marked as A in the drawing), and roll&fold the mouth, folding at the line marked as ① on the drawing. Making a proper crease on this line will make the stitch easier later.

2. Wrap the filter around the frame, matching the parting line (ear) of the filter with the handle shaft, folding at the line marked as ② on the  drawing.

3. Start the stitch from going into the back of ①出, coming out of ①出, very close to the shaft (the knot sits behind ①出.)

4. Secure the hold of the stitch around the shaft, sew going into ②入, coming out of ③出, going into ④入 then coming out of ⑤出. 

5. After that, use a slip stitch/invisible stitch with 5mm in between the stitches. Sew tightly so that the coffee grind won't spill into cups through stitches or around the shaft when brewing.

6. Once you come back around to the other side of the shaft, repeat the double stitch done at step 4, make a knot behind ①出、玉止め, and sew into ②入, coming out of ③出and go over to ④入, then come out at ⑤出, and snip the thread close to the exit.